1968 Chevelle / SS Exhaust System Kits
The 1968 Chevelle had two different dual exhaust system when GM outfitted these muscle cars. The small block dual exhaust cars recieved 2 1/2" head pipes and 2" tail pipes GM accomplished this by swaging down the head pipes to 2" The 1968 SS with the big 396 used 2 1/2" head pipes and 2 1/4" tail pipes that ended at the back of the car and pointed down and out.. Our exhaust system kits on all applications come with the correct head pipes with wrinkles and flats and correct tail pipes with wrinkles and double angle cut. The kit will also include corect mufflers logo deleted, correct muffler hangers, clamps, screws, installation instructions, diagrams and sealant. tail pipe hangers are available as well as retainers and strap clamps for reproduction authenticity. Ask about our concours pakgage to bump up to corded rubber zinc plated hangers, ss clamps, ceramic coated flanges, retainers and strap clamps. Or pull out all the stops and have us hand build you button head riveted hangers.

1968 - 1972 GM A- Body Front Hanger

These hangers are correct for 1968-1972 GM A-Body Exhaust Systems.For the longest time the only hangers available were actually for the 1964 - 1967 GM A body's. Alltough th hangers look extemely similar and will work just fine That is not good enough for Gardner. The hangers you see here are identilcle reprodutions of the unique 1968 to 1972 GM A body hangers. They have been painstakenly reproduced from our originals and come zinc plated hand built with lthe correct corded rubbers and button head rivets, zinc plated retainers and correct screws. They come standard with our 1968-1972 GM A body exhaust systems with the concourse package and are a Gardner Exclusive reproduction.

 

1968 Chevelle Tail Pipe Hanger

The 1968 Chevelle Tail Pipe hangers are another Gardner Exhaust Exclusive Reproduction. This hanger has long been unavailable for the enthusiast who has to have his car the way it came from the factory. It is similar to a GM A body tail hanger however, for some reason it makes use of only one strap. Our hangers are reproduced from the original pictured here and come hand built zinc plated with corded rubbers, button head rivets and attaching hardware.

2 1/4 " Strap Clamp

This strap clamp was used on many of the GM - A Body Muscle Cars. It was used to attach the tail pipes to the tail pipe hangers. Our strap clamps have been reproduced from the orginal shown here and come zinc plated with the correct sheet metal screw. They come standard with our concours show pkg. or can be optioned with one of our entire systems.