Gardner Exhaust Systems Home Muscle Car Exhaust System Profile Exhaust Systems Exhaust System Hardware Exhaust System Sound Clips Muscle Car Awards Gardner Exhaust Press Releases Gardner Exhaust System Testimonials Contact Gardner Exhaust
Exhaust Systems
Buick Exhaust Systems Buick
Camaro Exhaust Systems Camaro
Chevelle Exhaust Systems Chevelle
Corvette Exhaust Systems Corvette
El Camino Exhaust Systems El Camino
El Camino Exhaust Systems Firebird
GTO Exhaust Systems GTO
GTO Exhaust Systems Tri Five Chevys
Impala / Caprice / Biscayne Exhaust Systems Impala / Caprice / Biscayne
Nova Exhaust Systems Nova
oldsmobile Exhaust Systemswidth= Oldsmobile
Mopar Exhaust Systems Mopar
Hurst SC Rambler Exhaust Systems AMC

1967 Corvette HP SHP Small Block and Big Block Manual Transmission Systems

The 1967 Corvete Exhaust systems for the high horsepower small block and big block manual transmission cars both consisted of 2 1/2" front pipes and rear pipes" 2" outlet mufflers with stainless steel extensions The small block system had a welded in 2" section on each of the front pipes and our original pipes consisted of wrinkle bends on the small blocks but none on the big blocks so that is the way we build them.. Our kits come 14 ga aluminized with the corect front pipes, correct flanges, extensions, donuts, sealant, guillotine clamps, mufflers, installation instructions and diagrams. Reproduction center,and muffler hangers are available as well as stainless steel tips, heat riser and stud kit. Our system comes with flats in the rear pipes as original and flattened style u-bolts for center exhaust hanger. Ask about our concours show pkg. for the hobbiest who can't stand surface rust. (Mufflers are available in standard and N - 11 off road packages)


1967 Corvette 427 Side Exhaust

The 1965 - 1967 Big Block Corvette Side Exhaust is one of the more unique exhaust systems built during the muscle car era. This exhaust system was not for the faint of heart. It consisted of 2 1/2 inch pipes welded into a 2 3/4" chambered section. The section had numerous crimps in it to hold the unique internals inside. The system was finished off with a angle cut chrome tip that was welded to the 2 3/4 chambered section. The only attaching hardware for the system was a small bracket welded to the last crimp of the exhaust system. You should only consider this system if you like the roar of the car more than the sound of the radio.


Reproduction Exhaust Systems Sitemap Web Design Company
Gardner Exhaust Systems - 15 Glenn Pond Drive - Red Hook NY. 12571 - (845) 758-8003