Gardner Exhaust Systems Home Muscle Car Exhaust System Profile Exhaust Systems Exhaust System Hardware Exhaust System Sound Clips Muscle Car Awards Gardner Exhaust Press Releases Gardner Exhaust System Testimonials Contact Gardner Exhaust
 
Exhaust Systems
Buick Exhaust Systems Buick
Camaro Exhaust Systems Camaro
Chevelle Exhaust Systems Chevelle
Corvette Exhaust Systems Corvette
El Camino Exhaust Systems El Camino
Firebird Exhaust Systems Firebird
GTO Exhaust Systems GTO
Nova Exhaust Systems Nova
oldsmobile Exhaust Systemswidth= Oldsmobile
Mopar Exhaust Systems Mopar
Hurst SC Rambler Exhaust Systems Hurst SC Rambler
p
 
   
 

 

 

1966 Corvette HP SHP Small Block and Big Block Manual Transmission Systems

The 1966 Corvete Exhaust systems for the high horsepower small block and big block manual transmission cars both consisted of 2 1/2" front pipes and rear pipes" 2" outlet mufflers with stainless steel extensions The small block system had a welded in 2" section on each of the front pipes and our original pipes consisted of wrinkle bends on the small blocks but none on the big blocks so that is the way we build them.. Our kits come 14 ga aluminized with the corect front pipes, correct flanges, extensions, donuts, sealant, guillotine clamps, mufflers, installation instructions and diagrams. Reproduction center,and muffler hangers are available as well as stainless steel tips, heat riser and stud kit. Our system comes with flats in the rear pipes as original and flattened style u-bolts for center exhaust hanger. Ask about our concours show pkg. for the hobbiest who can't stand surface rust. (Mufflers are available in standard and N - 11 off road packages)


   
 
  Correct Reproduction N -11 (Offroad Muffler)
 
 
 

1966 Corvette Big Block Exhaust System Next To Gardner Exhaust Reproduction

 

 

 

 
  1966 Corvette Small Block HP Exhaust System Nest To Gardner Reproductions
 

"

1964 - 1968 Corvette Flattened Top 2 1/2" Guillotine Clamp

These clamps are an essential part of any concourse corvette restoration project. This clamp seen here has been reproduced from the original in the picture. Our clamps come with all the correct nuts and lock washers. They are only available in raw steel for the Corvette Purist

 

 

 

1964 - 1967 Corvette 2 1/2" Center Exhaust Hanger

Although this hanger is not one of our reproductions it is an excellent reproduction of the original hanger and we offer it with no apprehension.

 

   
 

1964 - 1967 Corvette Muffler Hanger

This hanger was used to hold the muffler in place at the back of the car. Our hangers are built with corded rubbers come with the correct screws and attaching hardware and are an excellent reroduction of the original hangers pictured here

 

 

1963 - 1967 Corvette Exaust Tip

Although this tip is not our reproduction we have compared it to original and they are a very nice reproduction. These tips have the original part number stamped in them. This tip is available with any of our 1963 - 1967 Corvette Exhaust System

 
   

 

 
Reproduction Exhaust Systems Sitemap Web Design Company
Gardner Exhaust Systems - 15 Glenn Pond Drive - Red Hook NY. 12571 - (845) 758-8003